Panasonic DMREZ28 Dvd Recorder - English / Spanish - Page 71
General Issues, Operation - replacement remote for
View all Panasonic DMREZ28 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
General Issues Operation Page Cannot operate the TV or Set • Change the manufacturer code on the remote control. 56 Top Box with the unit's remote • Select TV or Set Top Box mode on the remote control. 56 control. The remote control doesn't • The remote control code is wrong. Change to the correct code. 48 work. • The batteries are depleted. Replace them with new ones. 5 • Point the remote control at the remote control sensor on the main unit. 5 • Remove obstacles between the remote control and main unit. − • Remove dust from the transmission window and the unit's sensor. − • Colored glass may obstruct the signal reception/transmission. − • Don't place the signal sensor in direct sunlight or in areas that may be − subject to sun exposure. • It may be necessary to set the code on the remote control again after 48 changing the batteries. • It may be necessary to set the manufacturer code again after 56 changing the batteries. The unit is on but cannot be operated. • Some operations are prohibited by the disc. − • The unit is warm ("U59" appears on the unit's display). Wait until "U59" − disappears. • One of the unit's safety devices may have been activated. − Reset the unit as follows: Press [POWER 8] on the main unit to switch to off. If the unit doesn't switch to off, reset the unit (➔ 70, "To restore the unit if it freezes"). "U88" is displayed and the disc • The unit is carrying out the recovery process. Do the following to eject the disc: − cannot be ejected. (1) Press [POWER 8] on the main unit to switch to off. If the unit doesn't switch to off, reset the unit (➔ 70, "To restore the unit if it freezes"). (2) While the unit is off, press and hold [g] and [CH 1] on the main unit at the same time for about 5 seconds. (Ejection may take extra time depending on discs.) The disc may be defective. Try another disc. Cannot eject a disc. • The unit is recording. − • The unit may have a problem. Eject the disc as in (2) above. − Startup is slow. • Startup takes time in the following situations: − - A disc other than a DVD-RAM is inserted. - The clock is not set. - Immediately after a power failure or the AC power supply cord is connected. - When the unit is connected with an HDMI cable. A password screen appears • If the unit starts receiving a broadcast with the set rating information, 47 and you are unable to view or a password screen appears and you will be unable to view or record. record. Enter your password to continue. Time is incorrect after using • Try again. If the time is still incorrect, set the clock manually. 49 Auto Clock Setting. Cannot set "24p Output for • Only when the unit is connected to the HDMI terminal of a TV 55 DVD-Video". supporting 24p, you can set "24p Output for DVD-Video". In some cases where the unit is connected to a TV via an amplifier/receiver through the HDMI terminals, you may not be able to set it. In this case, connect the unit to a TV through the HDMI terminal and connect it to the amplifier/receiver through any terminal other than HDMI. Reference 71 RQT9046