Pfaff creative 2144 Owner's Manual - Page 6
Lowering, Disengaging, feed/dual, Removing, lifter, Attaching, embroidery - embroidery unit
View all Pfaff creative 2144 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
) HFpBooersofsohiorboeploehpoteoeommpsebelrbmeocirbdtoreaoriyicdd,reeesnaernttigyvuepyoCyuoarumdruPisf fttahlfoef wceermerabtthrioveiedfee2er1yd44udnopigtr,oispdeinsroleytnagatnatagdcehattehtdaec. hdutahlefeemedbr(oIDidTerSyysutneimt a),s described below. remove the knee It lift is not and fit the embroidery foot (see below). Lowering the feed dog The feed dog must be lowered for hoop embroidery. To lower the feed dog move the slide (4) to the left. Note: Raise the presser foot before lowering the feed dog The thread tension is automatically set and can be adjusted for speciality techniques. Disengaging the The top feed must be top feed/dual feed disengaged for embroidery work. Procedure: Hold the dual feed firmly at the ribbing with two fingers. Press the top and release it feed (red) fully slowly upward downwards, then pull it away from until it engages in normal position. you Removing the knee lifter The knee lifter is not needed for embroidery work and must be removed. To remove the knee lifter, just pull it out of the hole. I I - -: Zni Attaching the embroidery foot 1. Remove the standard presser foot. Carefully (S) until the cross-hole (T) is accessible. loosen the screw 2. Squeeze the embroidery of the foot into the cross foot hole gently of the together and guide presser foot holder the pin as far as it will go. 3. TTthoiegrheetmemnbotrvhoeeidtshecreyreewfmoob(trSot)o.idgeertyhefrooatnldoopsuellnitthoeutstcoretwhe (S). squeeze right. Tighten 1. the screw (S). 2. 3.