RCA HD61LPW42 User Guide & Warranty - Page 10

Things to Consider Before You Connect - model

Get RCA HD61LPW42 - 61inch Widescreen DLP HDTV PDF manuals and user guides
UPC - 034909312742
View all RCA HD61LPW42 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

Connections & Setup Things to Consider Before You Connect Protect Against Power Surges • Connect all components before you plug any of their power cords into the wall outlet or power strip. NEVER plug your TV into an outlet that is controlled by a wall switch. • Turn off the TV and/or component(s) before you connect or disconnect any cables. • Make sure all antennas and cables are properly grounded. Refer to the Important Safeguards sheet packed with your TV. Protect Components from Overheating • Don't block ventilation holes on any of the components. Arrange the components so that air can circulate freely. • Don't stack components. • If you place components in a stand, make sure you allow adequate ventilation. • If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won't flow around other components. Position Cables Properly to Avoid Audio Interference • Insert each cable firmly into the designated jack. Use Indirect Light Don't place the TV where sunlight or room lighting will be directed toward the screen. Use soft or indirect lighting. Using a Stand This television is a table model and is designed to set on a firm, flat surface. Placing the TV on soft carpeting or a like surface can block the bottom ventilation slots and result in reduced lifetime due to overheating. Make sure the stand or base you use is of adequate size and strength to prevent the TV from being accidentally tipped over, pushed off, or pulled off. This could cause personal injury and/or damage the TV. Refer to the Important Safety Instructions packed separately. Cables You Need to Connect Components to Your TV The pictures below show the cables (not supplied) you may need for the connections represented in this book. Note: Please locate the G-LINK cable (provided) when you're getting ready to set up your TV. You need to connect this cable to your TV and to your VCR and/or cable box in order for all of the features of the program guide to work properly. G-LINK cable Coaxial cable 8 S-Video cable DVI-D cable Ethernet Cable A/V Cable Digital Optical Cable 1394 Cable Composite Video Audio/ Video cable Speaker Wire Component Video Y•Pb•Pr cable Chapter 1

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
Connections & Setup
8
Chapter 1
Things to Consider Before You Connect
Protect Against Power Surges
•
Connect all components before you plug any of their power cords into the wall outlet or power strip. NEVER plug
your TV into an outlet that is controlled by a wall switch.
•
Turn off the TV and/or component(s) before you connect or disconnect any cables.
•
Make sure all antennas and cables are properly grounded. Refer to the Important Safeguards sheet packed with
your TV.
Protect Components from Overheating
•
Don’t block ventilation holes on any of the components. Arrange the components so that air can circulate freely.
•
Don’t stack components.
•
If you place components in a stand, make sure you allow adequate ventilation.
•
If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won’t flow around
other components.
Position Cables Properly to Avoid Audio Interference
•
Insert each cable firmly into the designated jack.
Use Indirect Light
Don’t place the TV where sunlight or room lighting will be directed toward the screen. Use soft or indirect lighting.
Using a Stand
This television is a table model and is designed to set on a firm, flat surface. Placing the TV on soft carpeting or a like
surface can block the bottom ventilation slots and result in reduced lifetime due to overheating. Make sure the stand or
base you use is of adequate size and strength to prevent the TV from being accidentally tipped over, pushed off, or
pulled off. This could cause personal injury and/or damage the TV. Refer to the Important Safety Instructions packed
separately.
Cables You Need to Connect Components to Your TV
The pictures below show the cables (not supplied) you may need for the connections represented in this book.
Note:
Please locate the G-LINK cable (provided) when you’re getting ready to set up your TV. You need to connect
this cable to your TV and to your VCR and/or cable box in order for all of the features of the program guide to work
properly.
S-Video cable
Ethernet Cable
Digital Optical Cable
Composite Video
Audio/ Video cable
Coaxial cable
DVI-D cable
Component Video
Y•Pb•Pr cable
Speaker Wire
A/V Cable
G-LINK cable
1394 Cable