Ricoh CL3000e Manual - Page 150

Options PAPER FEED UNIT Type 3000 Preparation A Check the contents of the package 1 When installing multiple options, for the following: install the Paper Feed Unit first. Up to two Paper Feed Units can be attached to the printer. When in- ❖ Paper Feed Unit (including a paper tray) stalling two Paper Feed Units, con- nect the two units first by following the procedure below be- fore connecting the units to the printer. Then, place the printer on the connected two Paper Feed Units. R CAUTION: • When moving the machine, each person should hold the handles that are located on opposite sides, and then lift the machine slowly. Lifting it carelessly or dropping it may cause an injury. • When moving the Paper Feed Unit, hold the handles that are located on the top of the unit, and then lift it slowly. Lifting it carelessly or dropping it may cause an injury. ZHBP310E B Turn off the power, and then un- plug the power cable. C Hold the Paper Feed Unit as shown in the illustration, and then place it on a flat surface near the place where the machine is to be installed. Note ❒ The printer weighs approximately 29.4 kg (64.8 lb.bond). ❒ The Paper Feed Unit weighs approximately 7.42 kg (16.4 lb.bond). ❒ "Tray 2" appears on the panel display when only one unit is installed. "Tray 3" appears on the panel display for the second unit when two units are installed. Note ❒ Be sure to work in a place with enough space, so that you can get behind the printer. 8