Ricoh CL3000e Manual - Page 63

Troubleshooting Messages/Second messages Description Solution Call Service: EC Power Off On A communication error sent from the engine to the controller. Turn the power switch off and on. If the message appears again, contact your sales or service representative. Cannot check Signal in Ad hoc The signal strength for the wireless LAN cannot be checked because "Ad hoc" is selected in "Comm. Mode" for "IEEE 802.11b" in the Host Interface menu. Change the transmission mode to [Infrastructure] in the Host Interface menu. Change Setting Tray # /Paper Size: Paper Type: 5 The paper size or paper type set in the indicated tray differs from the setting made. #: tray number Load paper of the selected size and type in the tray, and then change the paper setting with the control panel. Or press the {Form Feed} key several times until the tray with the desired paper type and paper size appears on the panel display. Or press the {Job Reset} key to cancel the print job. Close Front and/ or Right Cover The front or right cover of the Close the front or right cover printer is open. of the printer. Close Upper Left Cover The upper left cover of the printer is open. Close the upper left cover of the printer. Color Regist Error Color registration has failed. Turn the power switch off and on. If the message appears again, contact your sales or service representative. Error: Tray # Form Feed /Reset The Job Then Power OffOn There is a problem with the in- Press the {Form Feed} key to dicated tray. select another tray and make a #: tray number or Bypass Tray print, or turn the power switch off and on. If the mes- sage appears again, contact your sales or service repre- sentative. Hardware Problem Black PCU An error has occurred in the black PCU (Photo Conductor Unit). Turn the power switch off and on. If the message appears again, contact your sales or service representative. 54