Ricoh CL3000e Manual - Page 169

802.11b Interface Unit Type A I K Insert the card slowly into the Fasten the controller board to the 802.11b Interface Unit with the la- printer with the two screws that bel facing down and the uneven you removed in step C. black antenna surface facing up until it stops. 1 ZHBP210E J Align the controller board to the top and bottom rails, and then push in slowly until it stops. Note ❒ When installing other options on the controller board, do not close the controller board, but go to the steps for installing the option. ZHBP220E Important ❒ The printer may not work prop- erly if the controller board is not set properly. ZHBPB230E Note ❒ After finishing installation, you can check whether the 802.11b Interface Unit is installed properly. Print the configuration page from the "List/Test Print" menu. If it is installed properly, you will see "IEEE 802.11b" for "Controller Option". ❒ If the 802.11b Interface Unit is not installed properly, reinstall it from step B. If you cannot install it properly even after attempting reinstallation, contact your sales or service representative. Reference See "Making Printer Settings with the Control Panel" in the Administrator Reference for printing the configuration page. 27