Ricoh CL3000e Manual - Page 31

Paper and Other Media Loading Paper R CAUTION: • When pulling the paper tray out, be careful not to pull it strongly. If C Adjust the side guides to the pa- per size you want to load. you do, the tray might fall and 2 cause an injury. Loading Paper in Tray 1/Optional Paper Feed Unit A Pull the paper tray out of the printer until it stops. After that, lift it slightly, and then pull it out completely. Place it on a flat surface. ZHBY060E D Load paper into the paper tray with the print side up. ZHBY010E Note ❒ You can not pull Tray 1 out if the Bypass Tray is open. B Press "Push", and then adjust the rear guide to the paper size you want to load. 22 ZHBY040E ZHBY020E Important ❒ Make sure that the top of the stack is not higher than the limit mark inside the tray. ❒ The side guides should be set exactly to the paper size to avoid paper misfeeds. ❒ Do not load different kinds of paper in the tray. E Slide the paper tray completely into the printer. Important ❒ Be sure to insert the paper tray completely. Otherwise, misfeeds might occur.