Ricoh CL3000e Manual - Page 65

Troubleshooting Messages/Second messages Description Solution Hardware Problem Option RAM There is a problem with the optional Memory Unit. Remove and reinstall the optional Memory Unit. If the message appears again, contact your sales or service representative. See the Option Setup Guide. Hardware Problem Parallel I/F There is a problem with the parallel interface. If you use the parallel interface, replace the interface cable that caused the error. If the message appears again, contact your sales or service representative. Hardware Problem USB There is a problem related to the Universal Serial Bus Connection and Hardware. Remove and reinstall the USB board. If the message appears again, contact your sales or service representative. 5 Invalid Password Try Again The entered password is not Enter the correct password. correct. Load Correct Size Paper /Press # To Continue The paper size set in the indi- Load paper of the selected size cated tray differs from the set- in the tray, and then press the ting made. {Enter #} key to resume print- ing. If you want to ignore the message and continue print- ing, press the {Enter #} key. Load Paper /Paper Size: Paper Type The paper size set in the indicated tray differs from the setting made. Load paper of the selected size in the tray, and then change the paper size setting with the control panel. Or press the {Form Feed} key several times until the tray with the desired paper type and paper size appears on the panel display. Or press the {Job Reset} key to cancel the print job. Load paper of the selected type in the tray, and then change the paper size setting with the control panel. Or press the {Form Feed} key several times until the tray with the desired paper type and paper size appears on the panel display. Or press the {Job Reset} key to cancel the print job. 56