Ricoh CL3000e Manual - Page 470
Configuring NetBEUI for Printing, Configuring the printer, Configuring a Windows 95/98/Me computer
UPC - 026649201172
View all Ricoh CL3000e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 470 highlights
Operating Instructions Client Reference 27 Configuring NetBEUI for Printing Follow these instructions to configure the printer and Windows 95/98/Me to use the NetBEUI protocol. Limitation ❒ To use NetBEUI, use the SmartNetMonitor for Client port. ❖ Configuring the printer Configure the printer to use the NetBEUI protocol. • Confirm that the NetBEUI protocol is set to be active. (The factory default is active.) Reference For more information about how to make the above settings, see "Configuring the printer for the Network" in the Quick Installation Guide. ❖ Configuring a Windows 95/98/Me computer Install the NetBEUI protocol on the Windows 95/98/Me computer and set it as the default protocol. A Open [Control Panel] and double-click the [Network] icon. Confirm that "NetBEUI" is listed in the [The following network components are installed:] box under the [Configuration] tab. Note ❒ If the NetBEUI protocol is not installed, click [Add] under the [Configuration] tab and install it. For more information about installing the NetBEUI protocol, see Windows 95/98/Me Help. ❒ If "NetBEUI ->Dial-Up Adaptor" is listed in the [The following network components are installed:] box, select it, and then click [Remove] to remove the binding. B Set the NetBEUI protocol as the default protocol. Click the [Configuration] tab, select "Net- BEUI" in the [The following network components are installed:] box, and then click [Properties]. C Click the [Advanced] tab, select [Set this protocol to be the default protocol], and then click [OK]. D Click [OK] to close the [Network] dialog box. E When the message to restart appears, click [Yes].