Ricoh CL3000e Manual - Page 155

Memory Unit Type C (SDRAM Module) Memory Unit Type C (SDRAM Module) R CAUTION: C While holding the handle, pull • Do not touch the inside of the out the controller board slowly. 1 controller board compartment. It may cause a machine malfunc- tion or a burn. Important ❒ Before touching the Memory Unit, touch something metal to discharge any static electricity. Static electricity can damage the Memory Unit. ❒ Do not subject the Memory Unit to physical shocks. A Turn off the power, and then un- plug the power cable. B Remove the two screws that fas- ten the controller board on the back of the printer. ZHBP020E There are two slots for the Memory Unit. Use the available slot (the one in the front in the illustration B) to install an optional Memory Unit ZHBP080E The removed screws will be used in step G to fasten the controller board. ZHBP100E Important ❒ In order to install the maximum 384 MB memory, remove the standard Memory Unit A, and then replace with the 128 MB Memory Unit. Then install the 256 MB Memory Unit onto the other slot (the one in the front in the illustration B). ❒ When using only one Memory Unit, be sure to use the slot in the back shown in the illustration A. 13