Ricoh CL3000e Manual - Page 159

Printer Hard Disk Type 3000 E Insert the Printer Hard Disk by aligning it with the controller board slot, sliding it in the direction of the arrow, and then connecting it to the connector on the controller board. Note ❒ When installing other options on the controller board, do not close the controller board, but go to the steps for installing the 1 option. Important ❒ The printer may not work properly if the controller board is not set properly. H Fasten the controller board to the printer with the two screws that you removed in step C. ZHBP170E F Fasten the Printer Hard Disk us- ing the supplied screw. ZHBP180E G Align the controller board to the top and bottom rails, and then push in slowly until it stops. ZHBP070E ZHBP010E When the power is turned on, the Printer Hard Disk will be formatted automatically. Note ❒ After finishing installation, you can check whether the Printer Hard Disk is installed properly. Print the configuration page from the "List/Test Print" menu. If it is installed properly, you will see "Printer Hard Disk Drive" for "Controller Option". ❒ If the Printer Hard Disk is not installed properly, reinstall it from step B. If you cannot install it properly even after attempting reinstallation, contact your sales or service representative. 17