Ricoh Priport HQ7000 Network Guide - Page 121
The SAP function has started. The SAP SAP, An smbd SMB Server Message Block serv
View all Ricoh Priport HQ7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
Message List Message Causes and solutions Print queue cannot be serviced by printer 0, (In print server mode) The print queue name cannot be serviced. Make sure that print queue volume is on the specified file server. Print server has no printer. (In print server mode) The printer is not assigned to the print server . Using NWadmin, assign the printer, and then restart the printer device. Print sessions full Cannot accept the print session. Printer has no queue. (In print server mode) The print queue is not assigned to the printer. Using NWadmin, assign the print queue to the printer, and then restart it. pserver start. (NetWare) (In print server mode) NetWare service has started. Required computer name () is duplicated name. The same computer name is detected on the network. The start job determines the computer name by adding it to the suffix (0,1....). Configure a new computer name that is unique. Required file server () not Cannot find the required file server. found. restarted. LPD has started. sap enable, saptype=, sapname= The SAP function has started. The SAP (SAP type and SAP name) packet is issued to advertise the service on the NetWare server SAP table. session not defined. The requested community name is not de- fined. session_ipx not defined. The requested community name is not de- 9 fined. Set context to A has been set. shutdown signal received. network service re- Rebooting the network service. booting... smbd start. (NetBEUI) An smbd (SMB (Server Message Block) service) has started. Snmp over ip is ready. Communication over TCP/IP via SNMP is available. Snmp over ipx is ready. Communication over IPX via SNMP is available. snmpd start. SNMP service has started. started. Direct print service has started. 115