Ricoh Priport HQ7000 Network Guide - Page 25
Configuring a Windows NT 4.0 Computer, Control Panel, NetBEUI Protocol, Protocols, Services
View all Ricoh Priport HQ7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Configuring NetBEUI Configuring a Windows NT 4.0 Computer Follow the procedure below to configure a Windows NT 4.0 computer to use NetBEUI. A Open [Control Panel], and then double-click the Network icon. Make sure [NetBEUI Protocol] is listed in the [Network Protocols] box on the [Protocols] tab. Note ❒ If NetBEUI is not installed, click [Add...] on the [Protocols] tab to install it. For more information about installing NetBEUI, see Windows NT 4.0 Help. B Change the Lana Number. Click the [Services] tab, click [NetBIOS Interface] in the [Network Services] box, and then click [Properties...]. 4 C Click the Lana Number corresponding to the Nbf protocol in the [Network Route] column, and then click [Edit]. D Enter "0" as the Lana Number. Note ❒ If the other protocol's Lana Number is "0", you must change the Lana Number to a number other than "0". E Click [OK]. F Click [Close] to close the [Network] dialog box. The confirmation message about restarting appears. G Click [Yes]. Note ❒ After you change the Lana Number, you must restart the computer. 19