Sharp AR-M280 AR-M280 AR-M350 AR-M450 Operation Manual (for multifunction - Page 108
emulation switching}
View all Sharp AR-M280 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
KEY OPERATOR PROGRAMS System settings (Interface settings) These programs are used to set monitoring and restriction of data transmitted to the parallel port or network port of this printer. In "Interface Settings", the following programs can be set. G Hexadecimal dump mode G PDL for parallel port {Parallel port emulation switching} G PDL for network port {Network port emulation switching} G I/O timeout G Port switching Hexadecimal dump mode This program is used to output the print data from a computer in the hexadecimal dump format with corresponding characters (ASCII). This program is used to check proper transmission of print data from the computer to the printer. Output example of hexadecimal dump mode (A4 portrait) PDL for network port {Network port emulation switching} This program is used to specify a printer language to emulate for printing when the printer is connected to a computer through a network port. The setting items are the same as those of "PDL for parallel port". NOTE It is recommended to set "AUTO" (default setting) unless an error due to this setting occurs frequently. I/O timeout This program is used to cancel temporarily port connection or start next job when a preset time elapses to wait until print data is transmitted at the current port. Use this program to set the time from the state to wait for print data reception to the timeout state. NOTE The allowable range of the time is 1 to 999 seconds. PDL for parallel port {Parallel port emulation switching} This program is used to specify a printer language to emulate for printing when the printer is connected to a computer through a parallel port. Setting items Auto PostScript PCL Description The printer language will switch automatically in accordance with the data from the computer. PostScript emulation is used to print the data from the computer. (An optional PS3 expansion kit is needed.) PCL emulation is used to print the data from the computer. NOTE It is recommended to set "AUTO" (default setting) unless an error due to this setting occurs frequently. Port switching This program is used to set the switching method of the parallel port and network port of this printer. Setting item Description PER JOB After a print job is complete, {SWITCH AT automatic port selection state will END OF JOB} be restored. TIMEOUT After I/O timeout time (set with {SWITCH AFTER the program above) elapses, I/O TIMEOUT} automatic port selection state will be restored. DISABLE Printing from the parallel port is PARALLEL PORT disabled. DISABLE Printing from the network port is NETWORK PORT disabled. 6-12