Sharp AR-M280 AR-M280 AR-M350 AR-M450 Operation Manual (for multifunction - Page 77
Finisher
View all Sharp AR-M280 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
FINISHER If the finisher is installed, the offset function can be used. Each set of printed sheets is stacked offset from the previous set so that it can be easily taken out. Also each set of sorted sheets can be stapled. Part names Knob Hold this knob to open the finisher for misfeed removal. Top cover Open for misfeed removal. Top tray Paper output from the printer, copier, and fax features can be delivered here. The tray is extendable. To print onto large paper (8-1/2" x 14", 11" x 17", B4 or A3), extend the tray. Staple unit Pull out to replace the staple cartridge or to remove jammed staples. Stapler compiler Paper to be stapled is stacked temporarily. Offset tray The offset function and the stapling function can be used only in this tray. NOTES G Do not put pressure on the finisher (particularly each tray). G Be careful about the offset tray during printing because the tray moves up and down. G Some other peripheral units may be needed for installation of the finisher and some peripheral units cannot be installed together with the finisher. For combination of the peripheral units, see the list of combination of peripheral units on page xxxx. 5 Specifications Name Number of trays Exit system Tray type Paper capacity Paper size Paper weight Paper type Paper limit detection Offset function Paper size for stapling Stapling capacity Stapling position Reference paper position Power supply Dimensions Weight Finisher 2 Print face down Top tray: normal tray, Lower tray: offset tray Top tray: 500 sheets (8-1/2" x 11" or A4 size, 20 lbs. or 80 g/m2) Lower tray: 750 sheets (8-1/2" x 11" or A4 size, 20 lbs. or 80 g/m2) Top tray: Max. 11" x 17" or A3, Min. 5-1/2" x 8-1/2"R or A5R Lower tray: 8-1/2" x 11", A4 or B5R Top tray: 15 to 54 lbs. or 56 to 205 g/m2 Lower tray: 15 to 34 lbs. or 56 to 128 g/m2 Top tray: same as the specifications of paper for feeding in the main unit Lower tray: Provided in both the top tray and the lower tray Provided in the lower tray only, offset amount: 1.2 inch (30 mm) 8-1/2" x 11", A4, and B5 30 sheets (20 lbs. or 80 g/m2) Three types (one at rear, one at front, two at center) Center Drawn from the power supply unit (peripheral unit)(See page xx.) xx-x/x" (W) x xx-x/x" (D) x xx-x/x" (H) (xxx mm (W) x xxx mm (D) x xxx mm (H)) Approx. xxx lbs. (xx kg) Specifications are subject to change for improvement without notice. Supplies For the finisher, the following staple cartridge is needed as supplies. G Staple cartridge (Approximately 3,000 staples x 3) xxxx 5-9