Sharp AR-M280 AR-M280 AR-M350 AR-M450 Operation Manual (for multifunction - Page 98
Key Operator Programs - reset
View all Sharp AR-M280 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
KEY OPERATOR PROGRAMS This chapter describes the operation method of the key operator programs concerning the printer feature and the programs common to all features including the copier feature and the facsimile feature. These programs are provided for use by the key operator of this product. For key operator programs specific to the copier feature, facsimile feature, and network scanner feature, see the respective operation manuals.The key operator programs can only be accessed after a key operator code number has been entered. The titles displayed on the touch panel are shown with { }. NOTE Depending on the main unit model and installation of peripheral units, some key operator programs cannot be used. Key operator proguram list Program name Auditor settings Auditing mode Print per account {Total pages per account} Reset account {Resetting account} Account number control No print if account # invalid Energy save Auto power shut-off timer Preheat mode Toner save {Toner save in printer mode} Auto power shut-off Operation panel settings Auto clear setting Message display time Language setting {Beep setting} {Disabling of job priority operation} Device settings Disable duplex unit Disable stapler unit Disable paper desk drawers Disable finisher Disable mail-bin stacker Saddle stitch adjust Print key operator program list Key operator code change Page xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx System settings Default settings Print density level Disable notice page printing Disable test page printing A4/letter auto select Interface settings Hexadecimal dump mode PDL for parallel port {Parallel port emulation switching} PDL for network port {Network port emulation switching} I/O timeout Port switching Network settings IP address setting IP subnet mask IP gateway Enable TCP/IP Enable NetWare Enable EtherTalk Enable NetBEUI Reset the NIC Initialize/store settings Restore factory defaults Store current configuration Restore configuration Product key xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx 6-2