Sharp AR-M280 AR-M280 AR-M350 AR-M450 Operation Manual (for multifunction - Page 28
Loading Paper
View all Sharp AR-M280 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
LOADING PAPER When paper runs out during printing, a message indicating that paper runs out will appear. Follow the procedure below to load paper. NOTES G Do not use curled or folded paper. Doing so may cause a misfeed. G Use SHARP standard paper for paper tray 1. (See page xxxx.) G When you change the paper type in paper tray 1, set the paper type referring to "Method of setting paper size and type" (page xxxx). G Do not place a heavy object or press down hard on a tray when the tray is pulled out. Loading paper in paper tray 1 1 Pull out paper tray 1. Gently pull the tray out until it stops. 2 Load paper into the tray. Do not load paper above the maximum height line (approximately 500 sheets of 20 lbs. (80 g/m2) paper). 3 Gently push paper tray 1. Push the tray firmly all the way into the machine. 4 Set the paper type. If you change the paper type, be sure to set the paper type referring to "Method of setting paper size and type" (page xxxx). 5 Loading of paper in paper tray 1 is now complete. Changing the paper size in paper tray 1 For paper tray 1, 8-1/2" x 11", A4 or B5 size paper can be set. Use the following procedure to change the size as needed. 1 Pull out paper tray 1. If paper remains in the tray, remove it. 4 Gently push paper tray 1. Push the tray firmly all the way into the machine. 2 Adjust the guide plates A and B in the tray to the length and width of the paper. The guide plates A and B are slidable. Adjust them to the paper size to be loaded while squeezing their lock levers. 5 Set the paper size. Be sure to set the paper size and paper type referring to "Method of setting paper size and type" (page xxxx). If this operation is not performed after the paper size has been changed, printing will be made to paper of a size other than the specified size and a paper misfeed may occur. 3 Load paper into the tray. 1-18 6 Changing of paper size in paper tray 1 is now complete.