Sharp AR-MM9 Service Manual - Page 13

[4] OPERATION, DISPLAY SECTION 1. Operation panel 1 2 3 4 5 COPY PRINT ON LINE DATA SCAN DATA FAX JOB STATUS LINE DATA CUSTOM SETTINGS ACC.#-C 6 7 89 10 11 12 No. Name Function, operation 1 Touch panel • Messages and keys appears in the touch panel. A key can be touched to select or enter a setting. • When you touch a key, a beep sounds and the key is highlighted to indicate that it has been selected. • Keys that cannot be selected in a screen are grayed out. If a grayed out key is touched, a double beep will sound to indicate that the key cannot be selected. 2 Mode select keys Use to select the basic modes of the machine. 3 LINE light This lights while a fax is being sent or received. 4 Numeric keys Use for settings that require the entry of numbers. 5 [CLEAR] key This is used to clear a mistake when entering a number. One digit is cleared each time the key is pressed. The key is also used to cancel scanning of an original. 6 [FAX] key Press to switch to fax mode. The initial screen of fax mode will appear in the touch panel display. 7 [JOB STATUS] key Use to check the status of a job. 8 DATA light This light blinks when a fax has been received to memory. The light stays on constantly when a fax is waiting in memory for transmission. 9 [CUSTOM SETTINGS] key Use to customize the machine settings to better suit your needs. When using the fax function, destinations can be stored and settings for fax reception and fax forwarding can be selected. 10 [ACC.#-C] key Press to use the fax function when auditing mode is enabled. This key can also be used to issue tone signals when the machine is connected to a pulse dial line. 11 [START] key Press to begin scanning an original for fax transmission. 12 [CLEAR ALL] key Use to cancel a transmission or programming operation. When the key is pressed, the operation is canceled and you return to the initial screen. When sending a fax, this key is also used to cancel an image setting, paper size setting, or special function. 2. FAX mode (Condition setting screen) The condition setting screen of fax mode is displayed by pressing the [FAX] key while the print mode, copy mode, or job status screen appears in the touch panel. In the explanations that follow, it is assumed that the initial screen that appears after pressing the [FAX] key is the condition setting screen (shown below). If you have set the display to show the address directory when the [FAX] key is pressed, touch the [CONDITION SETTINGS] key in the address directory to display the condition setting screen. A key operator program can be used to set the display to show either the condition setting screen (shown below) or the address directory screen (p.8) when the [FAX] key is pressed. A. Condition setting screen The display is initially set (factory setting) to show the following screen when the [FAX] key is pressed. 1 READY TO SEND. 14 AUTO 13 EXPOSURE 12 STANDARD RESOLUTION 11 AUTO ORIGINAL 2 3 4 SPEAKER REDIAL FAX MEMORY:100% AUTO RECEPTION ADDRESS BOOK 5 SUB ADDRESS 6 SPECIAL MODES ADDRESS REVIEW 7 DIRECT TX MEMORY TX 8 10 9 AR-FX7 ADJUSTMENTS 4 - 1