Sharp AR-MM9 Service Manual - Page 26

Note: Executable only when the FAX is installed. 1 66-16 Purpose Operation check/test Function Used to perform the dial test. (DTFM signal send test) (Purpose) Section FAX Item Operation Operation/Procedure 1. Select the item with the 10-key, and press the [START] key. 2. Enter the set value with the 10-key. The sending dial cannot be interrupted. Item 0 EXECUTE 1 HIGH (SW) 2 HIGH-LOW (SW) 3. Select the soft SW reflection. Content Execution High group High group, Low group Setting range - 0-15 0-15 Item 1 NO STORE TO SW 2 STORE TO SW Content Not reflected. Reflected. (Shift SW value changed.) Note: Executable only when the FAX is installed. 1 66-17 Purpose Operation check/test Function Used to check the DTFM signal send operation. (Purpose) (Signal send level: Max.) Section FAX Item Operation Operation/procedure Enter the DTFM signal (1 digit (1 to 9, 0, *, #)) and press the [START] key. When the [CUSTOM SETTINGS] key is pressed during execution, the simulation is terminated. Note: Executable only when the FAX is installed. 66-19 Purpose Back up Function Used to write the SRAM data to the Flash ROM. (Purpose) Section FAX Item Data Operation/Procedure Select "1: YES" with the 10-key, and press the [START] key. The data are backed up. (When "2: NO" is selected, the simulation is canceled.) * The AR-FX5 data cannot be written into the AR-FX7. If it is executed, data are initialized and deleted. In addition, the AR-FX7 data cannot be used in the AR-FX5. Note: Executable only when the FAX is installed. 66-20 Purpose Back up Function Used to write the Flash ROM data to the SRAM. (Purpose) Section FAX Item Data Operation/Procedure Select "1: YES" with the 10-key, and press the [START] key. The Flash ROM data are read out and written into the SRAM. (When "2: NO" is selected, the simulation is canceled.) * The AR-FX5 data cannot be written into the AR-FX7. If it is executed, data are initialized and deleted. In addition, the AR-FX7 data cannot be used in the AR-FX5. Note: Executable only when the FAX is installed. 66-18 Purpose Operation check/test Function Used to check the DTFM signal send operation. (Purpose) (Signal send level: Set by soft SW.) Section FAX Item Operation Operation/Procedure Enter the DTFM signal (1 digit (1 to 9, 0, *, #)) and press the [START] key. When the [CUSTOM SETTINGS] key is pressed during execution, the simulation is terminated. 66-21 Purpose Check Function (Purpose) FAX information print Section FAX Item Data Operation/procedure 1. Select the item to be printed. 2. Press the [START] key. The information of the selected item is printed. Item 1 USER SW.LIST 2 SOFT SW.LIST 3 SYSTEM ERROR Content User setting list Soft SW list System error list Used to print the system error log (error number and time). AR-FX7 SIMULATION 6 - 10