Sharp AR-MM9 Service Manual - Page 28

66-33 Purpose Operation test/check Function (Purpose) Signal detection check Section FAX Item Operation Operation/Procedure Signal detection is checked and the result is displayed. Note: Executable only when the FAX is installed. 66-34 Purpose Function (Purpose) Section Item Operation test/check Communication time measurement display FAX Operation Operation/procedure The send/receive test is performed, and the time required for send/ receive of the image data in the test is measured and displayed. Setup on the user side when executing communication Measuring Send range Receive Mode when measuring How to check the time Measuring unit Communication : Memory send means : Normal Character Picture quality : Lighter Density : ON ECM : OFF Sender information From flag reception before sending of image data until sending of RCP frame From flag reception before reception of image data until reception of RCP frame Used to make communication not in a simulation process but in the normal screen and measure the time. Enter the simulation for communication time check and check the time. msec When there are two or more send/receive operations of image data in one communication, only the time of the last send/receive data near the end is measured. Note: Executable only when the FAX is installed. 1. Sound kinds pattern Sound kinds (Test sound) RINGER Call sound LINE MONITO Line monitor sound (Test sound: communication signal sound) ON HOOK On-hook (Test sound, communication signal sound) SCAN FINISH Scan finish sound TX/RX FINISH Communication finish sound DTMF DTFM send sound Sound volume set value DEF. LAR. MED. SMA. DEF. LAR. MED. SMA. DEF. LAR. MED. SMA. DEF. LAR. MED. SMA. DEF. LAR. MED. SMA. DEF. LAR. MED. SMA. LAR: (MED. Value + 1) MED: (SMA value +1) - (LAR value - 1) SMA: 1 - (MED. Value + 1) 2. Sound volume pattern Note: Executable only when the FAX is installed. 1 66-41 Purpose Adjustment/Setting/Check Function CI signal check (Purpose) Operation/procedure When the [START] key is pressed, the call signal from CI pin is detected to deliver the call sound to the line and the speaker. The volume of call sound follows the soft SW. Signal detection and delivery of pseudo-call sound at detection are executed until the interruption command is provided by pressing the [CUSTOM SETTINGS] key. Note: Executable only when the FAX is installed. 66-37 Purpose Adjustment/Setting/Check Function (Purpose) Speaker sound volume adjustment Section FAX Operation/procedure The following test sound is delivered to the line and the speaker to adjust the sound kind and volume. The send level to the line is the set value of soft SW. The set values of the selected sound kind and volume are written to each soft SW. AR-FX7 SIMULATION 6 - 12