Sharp AR-MM9 Service Manual - Page 31
Sharp AR-MM9 - Memory Board - DRAM Manual
![]() |
UPC - 074000074828
View all Sharp AR-MM9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
SW Data No. No. Items 1 Initialization control inside program SW selection and functions 1: The all soft switches are 0: Does nothing. initialized. 2 For FAX debug S 3 Flash memory check W measuring range 5 4 ICU UART1 output 1: Debug mode ON 1: All areas 1: Not output 5 24V reset wait time Binary 6 input Bit No. 7 Setting range 8 1 Auto/Manual default setup 1: Manual reception 0: Debug mode OFF 0: 256byte 0: Output 5678 0 to 750ms 0: Automatic reception 2 Inhibited to use 3 Size specification Bit No. 34 Centimeter size 0 0 Inch size 10 S4 W 6 Follows the machine information. Follows the 01 11 machine information. 5 Inhibited to use 6 Memory transmission/ 1: Direct transmission 0: Memory transmission direction transmission default setup 7 Quick memory transmission 1: Allowed 0: Inhibited 8 Remote reception 1: Yes 0: No instruction 1 Remote selection number Binary input 2 setup Bit No. 12345678 3 S W 4 75 6 Setting range 0 to 9 times 7 8 1 Image quality priority Bit No. 123 selection Standard 000 Fine 001 2 Super fine 010 Ultra fine 011 Not used 100 3 Fine 101 S Super fine + half 1 1 0 W tone 8 Ultra fine + half tone 1 1 1 4 Density default setup Bit No. 45678 Automatic 00000 5 Light 10000 Slightly light 01000 6 Middle 00100 7 Slightly dark 00010 8 Dark 00001 Default value Remarks Used to restrict Does nothing. 0 initialization inside the program. (Use inhibited) Debug mode OFF 0 256byte 0 Not output 500ms Automatic reception Follows the machine information. 1 1 0 1 0 Manual receive setting is enabled 0 only when an external telephone is connected. 0 When setting is 0 made to follow the machine information, if the machine information is incomplete, the 1 paper size is set to the centimeter size. Memory transmission Allowed Yes 5 0 0 1 1 0 When a value 0 outside the setting 0 value range is 0 inputted, the initial 0 value is set. 1 0 1 0 Standard 0 0 0 0 Automatic 0 0 0 AR-FX7 SOFT SWITCH 7 - 3
![](/manual_guide/products/sharp-armm9-service-manual-b289390/31.png)