Sharp AR-MM9 Service Manual - Page 37

SW Data No. No. Items SW selection and functions 1 Report output (in reception) Bit No. 12 Print is inhibited. 0 0 2 Print all 01 Only in case of an 1 0 error 3 Report output (in Bit No. 34 transmission) Print is inhibited. 0 0 4 Print all 01 Only when 10 S W 34 5 Communication report output (in confidential transmission is failed 1: Print 0: Not print reception) 6 Report output (In broadcast, Bit No. 67 sequential send request, 7 and relay broadcast) Print is inhibited. Print all 00 01 Only the address to 1 0 which transmission is failed 8 Report output when 1: Output 0: Not output canceling 1 Automatic reduction print 1: Allowed 0: Inhibited 2 Paper selection priority 1: Width priority 0: Area priority 3 Output condition setup Bit No. 34 Reduction allowed 0 0 S AB 01 W4 Division allowed 1 0 35 A 11 5 Automatic reduction rate Binary 6 setup 7 input Bit No. Setting range 5678 0 to 15% 8 1 Waiting time for PC-FAX job Binary 2 end 3 input Bit No. Setting range 1234 0 (32min) to 15 (2 min) 4 S 5 Inhibited to use W6 36 7 Waiting time for lift-up Bit No. 78 30sec 00 15sec 01 8 60sec 10 120sec 11 1 Thin paper setup 1: Allowed 0: Inhibited 2 Specification of 1m scan 1: Specification of 1m scan 0: Normal operation when there is no line send setting 3 Rotation send selection (A4 1: Yes 0: No → A4R) 4 Rotation transmission S W selection (B5R → B5) 37 5 Rotation transmission selection (A5R → A5) 1: Yes 1: Yes 0: No 0: No 6 Rotation transmission 1: Yes 0: No selection (11 x 8.5 → 8.5 x 11) 7 Inhibited to use 8 Rotation scan word 1: Round up 0: Round down calculation Default value 0 Print is inhibited. 0 1 Only when transmission is failed 0 Remarks Print 1 0 Print all 1 Not output 0 Allowed 1 Area priority 0 When the value is 0 outside the setting Reduction allowed range, the initial value is set. 0 0 1 6% 1 0 1 1 2 min 1 1 0 0 0 30sec 0 Inhibited 0 Normal operation 0 Yes 1 Yes 1 Yes 1 Yes 1 1 Round down 0 AR-FX7 SOFT SWITCH 7 - 9