Sony DCR-DVD300 Operating Instructions - Page 96
To Disconnect the USB cable, Safe to Remove Hardware - dvd handycam
UPC - 027242633155
View all Sony DCR-DVD300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Connecting your camcorder to your computer - Introduction To disconnect the USB cable See "To disconnect the USB cable" (page 96). To confirm the USB driver installation 1 Click [Start] t [Settings] t [Control Panel]. 2 Click [System]. "System Properties" screen appears. 3 Click [Device Manager]. "Device Manager" screen appears. 4 Make sure that "SONY DDX-A1000 USB Device" appears in CD-ROM, "Sony DVD Handycam" in Storage device, and "USB Mass Storage Device" in Universal Serial Bus controllers respectively. When all the devices appear, the USB driver is installed correctly. If any of these devices are not shown, install the USB driver again following "If you cannot install the USB driver" (page 97). To Disconnect the USB cable 1 Move the cursor to the "Unplug or Eject Hardware" icon on the Task Tray and click to cancel the applicable drive. 2 After the "Safe to Remove Hardware" dialog box appears, disconnect the USB cable and turn off your camcorder. Notes •Be sure to turn off your camcorder after disconnecting it from your computer. Turning off your camcorder keeping connection to the computer may prevent from normal disconnection. •Never disconnect the USB cable when the Access/Open lamp is lit in red. It may cause a damage to the disc. 96