Xerox 1235N Troubleshooting Guide - Page 103

Front Panel Messages (cont'd.) Message Replace Drum Replace Black Drum Replace Cyan Drum Replace Magenta Drum Replace Yellow Drum Replace Fuser Replace Transfer Belt RH Sensor Error T30 Power Off/On Type Fault Fault Fault Fault Roller Over Temp T31 Power Off/On Fault Roller Position Error U10 Power Off/On Fault Troubleshooting Explanation/Corrective Action The imaging drum has reached its end of life. Install a new imaging drum. The fuser has reached its end of life. Install a new fuser. The transfer belt has reached its end of life. Install a new transfer belt. The relative humidity sensor is either not communicating or reporting invalid data. Turn off the printer, wait 15 seconds, then turn on the printer. If the problem persists, check the support links at www.xerox.com/officeprinting/1235support. The fuser temperature sensor is reporting a temperature error. Turn off the printer, wait 15 seconds, then turn on the printer. If the problem persists, install a new fuser. For further assistance, visit the support links at www.xerox.com/officeprinting/1235support. An error has been detected with the pinch rollers not being in the expected position. Turn off the printer. Pull the pinch roller release lever, located on the right hand side of the printer, forward and then push backward to return the lever to its home position. Then turn on the printer. If the problem persists, check the support links at www.xerox.com/officeprinting/1235support. Advanced Features and Troubleshooting Manual 87