ZyXEL P-660HW-T1 v3 User Guide - Page 102
Network > WAN > Internet Access Setup - p t1 v3 default password
View all ZyXEL P-660HW-T1 v3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Chapter 6 WAN Setup The following table describes the labels in this screen. Table 19 Network > WAN > Internet Access Setup LABEL DESCRIPTION Line Modulation Select the modulation supported by your ISP. Use Multi Mode if you are not sure which mode to choose from. The ZyXEL Device dynamically diagnoses the mode supported by the ISP and selects the best compatible one for your connection. General Mode Encapsulation Other options are ADSL G.dmt, ADSL2, ADSL2+, ADSL2 AnnexM, ADSL2+ AnnexM, READSL2 Mode, ANSI T1.413 and ADSL G.lite. Select Routing (default) from the drop-down list box if your ISP gives you one IP address only and you want multiple computers to share an Internet account. Select Bridge when your ISP provides you more than one IP address and you want the connected computers to get individual IP address from ISP's DHCP server directly. If you select Bridge, you cannot use Firewall, DHCP server and NAT on the ZyXEL Device. Select the method of encapsulation used by your ISP from the dropdown list box. Choices vary depending on the mode you select in the Mode field. If you select Bridge in the Mode field, select either PPPoA or RFC 1483. User Name Password Service Name Multiplexing If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or PPPoE. (PPPoA and PPPoE encapsulation only) Enter the user name exactly as your ISP assigned. If assigned a name in the form user@domain where domain identifies a service name, then enter both components exactly as given. (PPPoA and PPPoE encapsulation only) Enter the password associated with the user name above. (PPPoE only) Type the name of your PPPoE service here. Select the method of multiplexing used by your ISP from the dropdown list. Choices are VC or LLC. Virtual Circuit ID This field is not available if you set the WAN type to Ethernet. VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit. Refer to the appendix for more information. These fields are not available if you set the WAN type to Ethernet. VPI The valid range for the VPI is 0 to 255. Enter the VPI assigned to you. VCI The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local management of ATM traffic). Enter the VCI assigned to you. 102 P-660HW-Tx v3 Series User's Guide