Canon imagePROGRAF iPF650 iPF650 655 750 755 Basic Guide Step2 - Page 34

Error Messages Error Message GARO Wxxxx (x represents a number) GL2: W0502 The parameter is out of range. GL2: W0504 This command is not supported. GL2: Wxxxx The memory is full.(xxxx is 0501, 0903, or 0904) No ink left. Ink insufficient. Not much ink is left. Unable to detect ink level correctly. Close Ink Tank Cover Ink tank is empty. Cause Corrective Action There is a problem with the print job. A parameter specified in an HPGL/2 command is out of the supported range. The printer has received an unsupported HP-GL/2 command. Try printing again, using the correct printer driver. It is also possible to continue printing in this state. However, you may not be able to obtain the desired printing results. Check the print job. If you have specified ProcessingOption > Warning > On in the Control Panel menu, set it to Off instead. Check the print job. If you have specified ProcessingOption > Warning > On in the Control Panel menu, set it to Off instead. The printer memory is full. Because the entire print job could not be received, the printer may not be able to print the entire original. Check the printing results. In the Control Panel menu, setting On-the-Fly to On may enable printing. However, check the printing results because the image may be incomplete in some cases. There is no ink left. Open the Ink Tank Cover and replace the Ink Tank for which the Ink Lamp is flashing. (→ , Replacing Ink Tanks) The ink level is low, so you cannot print, clean the Printhead, or do other operations that require ink. Press ▲ or ▼ to select Rep. Ink Tank, and then press the OK button. Replace the Ink Tank that is low with a new Ink Tank. (→ , Replacing Ink Tanks) Press ▲ or ▼ to select Continue to print, and then press the OK button to resume printing. However, note that this error may affect the printing quality. Not much ink is left. Prepare a new Ink Tank. We recommend replacing the Ink Tank with a new Ink Tank at this point if you plan to print large-format or high-quantity jobs. The remaining ink level could not Close the Ink Tank Cover. be correctly detected. The buzzer will stop once the error is cleared. The Ink Tank Cover is open. Close the Ink Tank Cover. The buzzer will stop once the error is cleared. There is no ink left in an ink tank. Open the Ink Tank Cover and replace the Ink Tank for which the Ink Lamp is flashing. (→ , Replacing Ink Tanks) 34