Compaq ProLiant 6400R Compaq ProLiant 6400R Servers - Page 121
Table 3-21, Compaq System Configuration Utility r Settings for Booting into Compaq Utilities
View all Compaq ProLiant 6400R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
3-54 Compaq ProLiant 6400R Maintenance and Service Guide Table 3-21 Compaq System Configuration Utility Pager Settings for Booting into Compaq Utilities continued Pager Data Setting Description Pager message 1234567# Represents a unique number (maximum of seven numeric only digits) that you must designate to identify the server on the pager display. The ROM adds a three-digit code to the front of the number. The first two indicate the subsystem, and the third indicates the severity of the error that caused the alert. The # symbol usually terminates the message. If no message is required, delete the # symbol. Pager test Select to test pager setup Test the current pager settings. Press Enter to dial the pager number, and the pager message (if present) displays. You must configure the computer before testing the pager, and the Pager Status must be set to Enabled. Do not test the pager if you run remotely and use only one modem. Serial interface COM1 Select the communications port for the modem used by the pager and the remote ASR-2 functions. The options are COM1 and COM2. Dial-in status Enabled Set Dial-In Status to Enabled. Be sure the Reset Boot option is set to Boot Compaq Utilities. When the system starts because of an ASR reset, it starts to the Compaq Utilities, sets the Management Modem to auto-answer, and waits for the administrator to dial in and run the Compaq Utilities. You automatically disable the option when you configure the software error recovery start option to Boot Operating System. When ASR pages you, you cannot dial in unless ASR-2 exceeds 10, the threshold number of server restart retries. When this happens, ASR-2 restarts the server into the Compaq Utilities and places the modem in auto-answer mode. Dial-out status Enabled Enables ASR-2 to dial a remote workstation. If you selected this option, Dial-In Status is automatically selected. To use the dial-out feature, set Dial-Out Status to Enabled, and set the Dial-Out String to the correct phone number. You must also set the Reset Boot option to Boot Compaq Utilities. When the system restarts because of an ASR reset, the administrator is paged by the Pager Status and Pager Dial String. The system restarts to the Compaq Utilities and dials the telephone number provided in the Dial-Out string. The number will be tried five times. If it fails to connect after five attempts, the modem is put in autoanswer mode. Dial-out string 555-1234 Enter the dial string followed by the remote computer telephone number. Network status To use IPX network access, set Network Protocol to IPX. When the system restarts to the Compaq Utilities because of an ASR reset, it loads IPX network support. This enables remote access using NVT. To use IP network access, set Network protocol to IP. Also make sure to set Network IP address, Network IP net mask, and Network IP router address. When the system restarts to the Compaq Utilities because of an ASR reset, it loads IP network support. This enables remote access using Telnet. Note: The Network Status must be set to Enabled for network access. continued