Compaq ProLiant 6400R Compaq ProLiant 6400R Servers - Page 78
Failure in Bay X
View all Compaq ProLiant 6400R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Diagnostics and Troubleshooting 3-11 Table 3-2 POST Error Messages continued Error Code Audible Beeps 1611-I/O Fan (Fan 5) failure detected 2 short Processor X None initialized at 550/100 System fans not redundant 1611-CPU Fan (Fan X) failure detected 1612-Primary power supply failure 1613-Low System Battery 1615-Power Supply Failure, Power Supply Unplugged, or Power Supply Fan Failure in Bay X 1617-Fan controller not responding 1617-I/O Fan controller not responding 1617-CPU Fan controller not responding 1618-PCI slots powered down. Check PCI hot plug enabler connectors. 1620-Locked SCSI Bus Detected. Verify SCSI bus cabling. System halted. 1621-Current SCSI bus cable configuration is not recommended 2 short 2 short None None 2 short 2 short 2 short None None None Probable Source of Problem I/O fan 5 or 6 has failed. Recommended Action Replace the failed fan. Processors upgraded to 550-MHz, but external hot-plug rear CPU fan not replaced with external rear hot-plug system fan assembly CPU fan has failed. Verify that the correct fan assembly was installed properly and that the switch settings are correct (SW1, position 3). Check for fan failure, and replace if needed. Replace the failed fan. Primary power supply has failed. Real-time clock system battery is running low on power. A power supply has failed. Replace power supply as soon as possible. Run Diagnostics. Replace the failed assembly as indicated. Replace or check the specified power supply. Fan controller failure I/O fan controller failure Check and replace the failed controller assembly. Check and replace the failed controller assembly. CPU fan controller failure Check and replace the failed controller assembly. PCI hot plug enabler is missing or Check and replace the missing failed. or failed assembly. SCSI bus failure Run Diagnostics. Replace the failed assembly as indicated. Improper SCSI bus cabling Check the documentation for the proper SCSI bus cabling. continued