D-Link DES-3028 Product Manual - Page 33

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Managed Switch DES-3028G:4#show switch Command: show switch Device Type MAC Address IP Address VLAN Name Subnet Mask Default Gateway Boot PROM Version Firmware Version Hardware Version Serial Number System Name System Location System Contact Spanning Tree GVRP IGMP Snooping VLAN trunk 802.1X TELNET WEB RMON SSH : DES-3028G Fast Ethernet Switch : 00-21-91-98-60-77 : 10.73.21.11 (Manual) : default : 255.0.0.0 : 0.0.0.0 : Build 1.00.B06 : Build 2.00.B26 : A1 : P4IG188000007 : : : : Disabled : Disabled : Disabled : Disabled : Disabled : Enabled(TCP 23) : Enabled(TCP 80) : Disabled : Disabled CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All Figure 4- 4. Show switch command The Switch's MAC address can also be found from the Web management program on the Switch Information (Basic Settings) window on the Configuration menu. The IP address for the Switch must be set before it can be managed with the Web-based manager. The Switch IP address can be automatically set using BOOTP or DHCP protocols, in which case the actual address assigned to the Switch must be known. The IP address may be set using the Command Line Interface (CLI) over the console serial port as follows: Starting at the command line prompt, enter the commands config ipif System ipaddress xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy Where the x's represent the IP address to be assigned to the IP interface named System and the y's represent the corresponding subnet mask. Alternatively, you can enter config ipif System ipaddress xxx.xxx.xxx.xxx/z. Where the x's represent the IP address to be assigned to the IP interface named System and the z represents the corresponding number of subnets in CIDR notation. The IP interface named System on the Switch can be assigned an IP address and subnet mask, and then be used to connect a management station to the Switch's Telnet or Web-based management agent. 19