Dell PowerConnect 5324 User's Guide - Page 143
show fiber-ports optical-transceiver, Optical Transceiver Diagnostics Table, Voltage, Current
View all Dell PowerConnect 5324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
Table 6-34. Fiber Optic Cable Test CLI Commands CLI Command show fiber-ports optical-transceiver [interface][detailed] Description Displays the optical transceiver diagnostics. The following is an example of the CLI command: console> enable Console# show fiber-ports optical-transceiver Power Port Temp Voltage Current Output Input TX LOS (C) (Volt) (mA) (mWatt) (mWatt) Fault g1 W OK E g2 OK OK OK g3 Copper OK OK OK OK OK OK E OK Temp - Internally measured transceiver temperature. Voltage - Internally measured supply voltage. Current - Measured TX bias current. Output Power - Measured TX output power. Input Power - Measured RX received power. Tx Fault - Transmitter fault LOS - Loss of signal The Optical Transceiver Diagnostics Table contains the following columns: • Temp - Internally measured transceiver temperature. • Voltage - Internally measured supply voltage. • Current - Measured TX bias current. • Output Power - Measured TX output power in milliwatts. • Input Power - Measured RX received power in milliwatts. • TX Fault - Transmitter fault. NOTE: Finisair transceivers do not support the transmitter fault diagnostic testing. Configuring System Information 143