Dell PowerConnect 5324 User's Guide - Page 253
interface ethernet, When selected, enables PPP sending Link Control Protocol
View all Dell PowerConnect 5324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 253 highlights
protocol can be sent over the link. The link remains configured for communications until explicit LCP or NCP packets close the link, or until some external event occurs. This is the actual device port link type. It may differ from the administrative state. Point-to-Point Operational Status - The Point-to-Point operating state. Activate Protocol Migrational Test - When selected, enables PPP sending Link Control Protocol (LCP) packets to configure and test the data link. Enabling RSTP 1 Open the Rapid Spanning Tree (RSTP) page. 2 Define the Point-to-Point Admin, Point-to-Point Oper, and the Activate Protocol Migration fields. 3 Click Apply Changes. Rapid STP is enabled, and the device is updated. Defining Rapid STP Parameters Using CLI Commands The following table summarizes the equivalent CLI commands for defining Rapid STP parameters as displayed in the Rapid Spanning Tree (RSTP) page. Table 7-63. RSTP Settings CLI Command CLI Command Description spanning-tree link-type {point-to- Overrides the default link-type setting. point | shared} spanning tree mode {stp | rstp} Configure the spanning tree protocol currently running. clear spanning-tree detectedprotocols [ethernet interface | port-channel port-channelnumber] Restarts the protocol migration process. show spanning-tree [ethernet interface | port-channel portchannel-number] Displays spanning tree configuration. The following is an example of the CLI commands: Console(config)# interface ethernet g5 Console(config-if)# spanning-tree link-type shared Configuring Device Information 253