Dell PowerVault DL2200 Hardware Owner's Manual - Page 105
the socket is ready for the new processor.
View all Dell PowerVault DL2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
Figure 3-18. Installing and Removing the Heat Sink 1 2 1 heat sink heat-sink 2 retention screws (4) 10 Rotate the processor shield upward and out of the way. See Figure 3-19. 11 Lift the processor out of the socket and leave the release lever up so that the socket is ready for the new processor. CAUTION: Be careful not to bend any of the pins on the ZIF socket when removing the processor. Bending the pins can permanently damage the system board. NOTE: In single-processor configurations, a processor must be installed in socket CPU1. Install the blank in socket CPU2 only. Installing System Components 105
Installing System Components
105
Figure 3-18.
Installing and Removing the Heat Sink
10
Rotate the processor shield upward and out of the way. See Figure 3-19.
11
Lift the processor out of the socket and leave the release lever up so that
the socket is ready for the new processor.
CAUTION:
Be careful not to bend any of the pins on the ZIF socket when removing
the processor. Bending the pins can permanently damage the system board.
NOTE:
In single-processor configurations, a processor must be installed in socket
CPU1. Install the blank in socket CPU2 only.
1
heat sink heat-sink
2
retention screws (4)
2
1