Dell PowerVault DL2200 Hardware Owner's Manual - Page 121
Power Distribution Board, Removing the Power Distribution Board
View all Dell PowerVault DL2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
Power Distribution Board The power distribution board is located on your system directly behind the power supply fan module. See Figure 3-25. Removing the Power Distribution Board CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Remove the internal hard drive bay and support carrier. See "Removing an Internal Hard Drive Bay" on page 71. 2 If applicable, remove the thumb screw on the support bracket and lift it up and out of the system. 3 Remove the power supplies from the system. See "Removing a Power Supply" on page 78. 4 Remove the expansion cards. See "Removing an Expansion Card" on page 92. 5 Remove the expansion card riser. See "Removing an Expansion-Card Riser" on page 93. 6 Disconnect power distribution cables from the system board (see "System Board" on page 124). 7 Disconnect the fan cable. 8 Remove the three screws securing the power distribution board to the chassis using the #2 phillips screw driver. See Figure 3-25. 9 Pull the blue tab, lift the power distribution board, and move it toward the front of the system to disengage from the tabs on the power supply bay. See Figure 3-25. Installing System Components 121