Dell PowerVault DL2200 Hardware Owner's Manual - Page 120
Installing the SAS Backplane, Connect the SAS data and power cables to the SAS backplane.
View all Dell PowerVault DL2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
Installing the SAS Backplane CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Lower the backplane into the system, being careful to avoid damaging components on the face of the board. 2 Align the slots in the backplane with the retention hooks on the back of the drive bays, then move the backplane forward until the retention hooks fit through the slots in the backplane. See Figure 3-24. 3 Slide the backplane downward until the two blue retention latches snap into place. 4 Connect the SAS data and power cables to the SAS backplane. 5 Install the hard drives in their original locations. 6 Connect the USB cable and the control panel cable to the system board. CAUTION: Handle the cables gently to prevent damage. 7 Connect the internal hard-drive cables. 8 Close the system. See "Closing the System" on page 65. 9 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals. 120 Installing System Components