Dell PowerVault DL2200 Hardware Owner's Manual - Page 69
Installing a Hot-Swap Hard Drive, If applicable
View all Dell PowerVault DL2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Figure 3-6. Removing and Installing a Hot-Swap Hard Drive 1 2 1 release button 2 hard-drive carrier handle Installing a Hot-Swap Hard Drive CAUTION: Use only hard drives that have been tested and approved for use with the SAS/SATA backplane. CAUTION: When installing a hard drive, ensure that the adjacent drives are fully installed. Inserting a hard-drive carrier and attempting to lock its handle next to a partially installed carrier can damage the partially installed carrier's shield spring and make it unusable. CAUTION: To prevent data loss, ensure that your operating system supports hot-swap drive installation. See the documentation supplied with the operating system. CAUTION: Combining SATA and SAS hard drives in the same system configuration is not supported on all configurations. 1 If applicable, remove the front bezel. See "Removing the Front Bezel" on page 63. 2 If a drive blank is present in the bay, remove it. See "Removing a Hard-Drive Blank" on page 67. 3 Press the button on the front of the drive carrier. Installing System Components 69