Dell PowerVault DL2200 Hardware Owner's Manual - Page 30

in BIOS. The BIOS setting, USB cables and SAS/SATA

Page 30 highlights

Message Causes Corrective Actions Read fault Requested sector not found. The operating system cannot Replace the USB medium read from the hard drive or and device. Ensure that the USB device, the system could USB cables and SAS/SATA not find a particular sector on backplane cables are properly the disk, or the requested connected. sector is defective. See "Troubleshooting a USB Device" on page 130 or "Troubleshooting a Hard Drive" on page 139 for the appropriate drive(s) installed in your system. SATA Port x device not found. There is no device connected Information only. to the specified SATA port. Sector not found. Faulty hard drive, USB Seek error. device, or USB medium. Seek operation failed. Replace the USB medium or device. Ensure that the USB or SAS backplane cables are properly connected. See "Troubleshooting a USB Device" on page 130 or "Troubleshooting a Hard Drive" on page 139 for the appropriate drive(s) installed in your system. Shutdown failure. General system error. See "Getting Help" on page 157. Sparing mode disabled. For sparing mode, matched sets of three must be populated across slots. The memory configuration does not match the setting in BIOS. The BIOS setting has been disabled. Reconfigure the memory modules for Memory Sparing mode. See "System Memory" on page 80. 30 About Your System

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164

30
About Your System
Read fault
Requested sector
not found.
The operating system cannot
read from the hard drive or
USB device, the system could
not find a particular sector on
the disk, or the requested
sector is defective.
Replace the USB medium
and device. Ensure that the
USB cables and SAS/SATA
backplane cables are properly
connected.
See "Troubleshooting a USB
Device" on page 130 or
"Troubleshooting a Hard
Drive" on page 139 for the
appropriate drive(s) installed
in your system.
SATA Port
x
device not
found.
There is no device connected
to the specified SATA port.
Information only.
Sector not found.
Seek error.
Seek operation
failed.
Faulty hard drive, USB
device, or USB medium.
Replace the USB medium or
device. Ensure that the USB
or SAS backplane cables are
properly connected. See
"Troubleshooting a USB
Device" on page 130 or
"Troubleshooting a Hard
Drive" on page 139 for the
appropriate drive(s) installed
in your system.
Shutdown
failure.
General system error.
See "Getting Help" on
page 157.
Sparing mode
disabled. For
sparing mode,
matched sets
of three must
be populated
across slots.
The memory configuration
does not match the setting
in BIOS. The BIOS setting
has been disabled.
Reconfigure the memory
modules for Memory
Sparing mode. See "System
Memory" on page 80.
Message
Causes
Corrective Actions