Garmin GPSMAP 3210 Owner's Manual - Page 119

Not All Maps Fit, Some Maps will not be drawn-the maximum number of individual maps on the data card was exceeded. Off Course Alarm-you exceeded the specified off-course distance. Proximity Alarm Memory is Full-you used all available proximity waypoints. Proximity Alarm: -you entered the alarm radius for the proximity waypoint indicated. Proximity Overlaps Another Proximity Waypoint-the alarm radius specified overlaps the area specified for another proximity waypoint. Adjust the distance. Route Already Exists: -you entered a route name that already exists in memory. Modify the route name or delete the previous route name. Route Is Full-you attempted to add more than 300 points to a route. Reduce the number of points or create a second route. Route Memory Is Full, Can't Create Route-the maximum amount of 300 routes is already in the unit's memory, and no additional routes can be added until existing ones are removed. Route Truncated-an uploaded route from another device has more than 300 points and was truncated to fit. Route Waypoint Memory Full-no additional route waypoints can be saved Shallow Water Alarm-the Shallow Water Alarm depth has been reached. Simulating Operation-the unit is in Simulator Mode. Do not use this mode for normal navigation! Sonar Failed, Unit Needs Repair-there is an internal problem with the unit. Contact your dealer or Garmin Product Support to have the unit serviced. Sonar Service Incompatible-the external sonar device you are connected to needs a software update. Appendix > Messages and Alarms Sonar Service Lost-the external sonar device you were connected to has either been disconnected or the GPSMAP 3206/3210 has lost communication with the sonar device for some other reason. Timer Alarm-the Timer Alarm value has counted down to 00:00:00. Track Already Exists: -you entered a saved track name that already exists in memory. Modify the track name or delete the existing track. Track Memory Is Full, Can't Create Track-the track log memory is full. No additional track log data can be stored without deleting old data to create memory space. Track Truncated-a complete uploaded track does not fit into memory. The oldest track log points were deleted to make space for the most recent data. Transducer Disconnected, Sonar Turned Off-there is not a transducer attached, bad cable/transducer, or the transducer cable was disconnected. If the transducer cable is removed while the unit is on, reconnect and cycle power. Transfer Complete-the unit has finished uploading or downloading information to the connected device. User Card Not Found-you attempted to transfer user data without a data card containing user data in the data card slot. Water Speed Sensor is not Working-the speed sensor is not detected. Check the connections. Water Temperature Alarm-sonar has reported a temperature above, below, inside, or outside the specified values. Waypoint Already Exists: -you entered a waypoint name that already exists in memory. Modify the waypoint name or delete the existing waypoint. Waypoint Memory Is Full Can't Create Waypoint-you have used all 4,000 waypoints available. Delete unwanted waypoints to make space for new entries. Appendix GPSMAP 3206/3210 Owner's Manual 111