HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Routing Confi - Page 82

Step Command Remarks 2. Enter interface view. interface interface-type interface-number N/A By default, the network type of an interface depends on the link layer protocol. After you configure the OSPF 3. Configure the OSPF network network type for an interface as type for the interface as ospf network-type p2mp [ unicast ] P2MP unicast, all packets are unicast P2MP. over the interface. The interface cannot broadcast hello packets to discover neighbors. In that case, you need to manually specify the neighbors. 4. Exit to system view. quit N/A 5. Enter OSPF view. 6. Specify a neighbor and its router priority on a P2MP unicast network. ospf [ process-id | router-id router-id | vpn-instance vpn-instance-name ] * peer ip-address [ cost value | dr-priority dr-priority ] N/A Required if the interface type is P2MP unicast. Configuring the P2P network type for an interface Step 1. Enter system view. 2. Enter interface view. Command system-view interface interface-type interface-number 3. Configure the OSPF network type for the interface as P2P. ospf network-type p2p Remarks N/A N/A By default, the network type of an interface depends on the link layer protocol. Configuring OSPF route control This section describes how to control the advertisement and reception of OSPF routing information, as well as route redistribution from other protocols. Configuration prerequisites Before you configure OSPF route control, complete the following tasks: • Configure IP addresses for interfaces. • Configure OSPF basic functions. • Configure filters if routing information filtering is needed. 72