HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Routing Confi - Page 94

Configuring OSPF network management With trap generation enabled, OSPF generates traps to report important events. Traps fall into the following levels. • Level-3-Fault traps • Level-4-Alarm traps • Level-5-Normal but important traps • Level-6-Notification traps The generated traps are sent to the information center of the device. The output rules of the traps such as whether to output the traps and the output direction are determined according to the information center configuration. (For information center configuration, see Network Management and Monitoring Configuration Guide.) To configure OSPF network management: Step 1. Enter system view. Command system-view Remarks N/A 2. Bind OSPF MIB to an OSPF process. ospf mib-binding process-id Optional. By default, the OSPF process with the smallest process-id is bound with OSPF MIB. 3. Enable OSPF trap generation. snmp-agent trap enable ospf [ process-id ] [ ifauthfail | ifcfgerror | ifrxbadpkt | ifstatechange | iftxretransmit | lsdbapproachoverflow | lsdboverflow | maxagelsa | nbrstatechange | originatelsa | vifcfgerror | virifauthfail | virifrxbadpkt | virifstatechange | viriftxretransmit | virnbrstatechange ] * Optional. Enabled by default. Enabling message logging Step 1. Enter system view. 2. Enter OSPF view. 3. Enable message logging. Command system-view ospf [ process-id | router-id router-id | vpn-instance vpn-instance-name ] * enable log [ config | error | state ] Remarks N/A N/A Not enabled by default. Enabling the advertisement and reception of opaque LSAs With this feature enabled, OSPF can receive and advertise Type 9, Type 10, and Type 11 opaque LSAs. To enable the advertisement and reception of opaque LSAs: 84