HP Color LaserJet 4730 HP Color LaserJet 4730mfp - User Guide - Page 274
PRINTER ERROR, To continue, turn off then on, NO SYSTEM, PRINTER ERROR, X.X OUTPUT, DEVICE CONDITION
View all HP Color LaserJet 4730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 274 highlights
Control panel message 60.X PRINTER ERROR alternates with To continue turn off then on 62 NO SYSTEM To continue turn off then on 64 PRINTER ERROR To continue turn off then on 65.X.X OUTPUT DEVICE CONDITION 65.X.X OUTPUT DEVICE DISCONNECTED 66.XX.X OUTPUT DEVICE FAILURE Description Recommended action A tray lifting error has occurred, where X is 1. Use the scroll bar to step through the the number of the tray. instructions. 2. Turn the MFP off then on. 3. If the error does not clear, record the message and contact HP Support at http://www.hp.com/support/clj4730mfp. No system was found. 1. Turn the MFP off then on. 2. If the problem persists, contact HP Support at http://www.hp.com/ support/clj4730mfp. A scan buffer error has occurred. 1. Turn the MFP off, and then turn the MFP on. 2. Check that the accessory is properly seated on and connected to the MFP, without any gaps between the MFP and the accessory. If the accessory uses cables, disconnect and reconnect them. Ensure that all connecting screws are tightened. 3. If this message persists, contact an HPauthorized service or support provider. See the HP support flyer, or go to http://www.hp.com/suppport/ clj4730mfp. An external output device has a condition that needs attention before printing can resume. Turn the MFP off then on. If necessary, reseat the output device. Ensure that the output device is connected and the cable is tightened. Communication between the MFP and the 1. device has been broken. The device could be disconnected. 2. Turn the MFP off. Replace the stapler/ stacker on the MFP. Turn the MFP on. Check that the accessory is properly seated on and connected to the MFP, without any gaps between the MFP and the accessory. If the accessory uses cables, disconnect and reconnect them. Ensure that all connecting screws are tightened. 3. If the error does not clear, record the message and contact HP Support at http://www.hp.com/support/clj4730mfp. An error occurred in an external paper handling accessory. 1. Turn the power off. 2. Check that the accessory is properly seated on and connected to the MFP, without any gaps between the MFP and the accessory. If the accessory uses cables, disconnect and reconnect them. Ensure that all connecting screws are tightened. 254 Chapter 12 Solving problems ENWW