HP Color LaserJet 4730 HP Color LaserJet 4730mfp - User Guide - Page 292
Sanitizing Disk X% Complete, Tray X=papershort
View all HP Color LaserJet 4730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 292 highlights
Control panel message Request accepted please wait Resend upgrade Restoring... [accessory #] Restoring... Restoring... factory settings Rotating motor To exit press Stop Rotating motor To exit press Stop SANITIZING DISK X% COMPLETE DO NOT POWER OFF SCAN CARRIAGE LOCKED Check lock switch, cycle power. Scan Failure Press "START" to rescan Setting saved SIZE MISMATCH TRAY X=paperShort For help press alternates with Ready Sleep mode on Description Recommended action ● Install the new transfer unit. ● Close the front and top covers. ● Supplies ordering information is also available from the embedded Web server. See Using the embedded Web server for more information. The MFP has accepted a request to print an No action necessary. internal page, but the current job must finish printing before the internal page will print. The firmware upgrade was not completed successfully. Attempt upgrade again. The MFP is restoring external accessory settings in response to a user request. No action necessary. The MFP is restoring settings. This message is displayed during the execution of a restore action, such as RESTORE COLOR VALUES. No action necessary. The MFP is restoring factory settings. No action necessary. A component test is in progress; the Press Stop when ready to stop this test. component selected is the cartridge motor. The MFP is executing a component test and Press Stop when ready to stop this test. the component selected is a motor. A storage device is being sanitized. Do not No action necessary. turn the MFP off. When the process is complete, the MFP will automatically restart. The flatbed scanner carriage is locked for shipping. Turn off the MFP, unlock the scanner carriage, and turn on the MFP. The scan was unsuccessful and the document needs to be rescanned. If necessary, reposition the document to rescan it, and then press Start. A menu selection has been saved. No action necessary. The tray is loaded with paper that is longer or 1. shorter in the feed direction than the size configured for the tray. 2. Adjust the side and rear media guides against the paper. If necessary, touch OKafter the tray is closed to change the paper size or type configuration to match the size or type of paper loaded in the tray. The MFP is in sleep mode. A button press, No action necessary. receipt of printable data, or an error condition will clear this message. 272 Chapter 12 Solving problems ENWW