HP Color LaserJet CM4730 Service Manual - Page 78

Security features Several important security features are available for the MFP. Use the information in this section to configure these features to meet the user's needs. Secure the embedded Web server Assign a password for access to the embedded Web server so that unauthorized users cannot change the MFP settings. 1. Open the embedded Web server by typing the IP address. 2. Click the Settings tab. 3. On the left side of the window, click Security. 4. Type the password next to New Password, and type it again next to Verify Password. 5. Click Apply. Make note of the password, and store it in a safe place. Foreign Interface Harness (FIH) The Foreign Interface Harness (FIH) provides a portal on the MFP. By using the FIH and third-party equipment, information about copies that are made on the MFP can be tracked. Requirements ● Windows 2000, Windows Server 2003, Windows XP, or Windows Vista ● Access to third-party accounting hardware solutions, such as Equitrac or Copitrak devices Using the FIH To use the FIH, download and install the FIH software. The software is available from http://www.hp.com/support/ljcm4730mfp_software. The software is used to enable or disable the FIH portal. Use the software to set and change the administrator personal identification number (PIN). Administrators can use the PIN option to configure the FIH to prevent any unauthorized changes. Changes can be made only with the correct PIN authentication. NOTE: It is important to remember the PIN that is assigned to the FIH administration software. The PIN is required to make any changes to the FIH. Enable the FIH portal 1. Double-click the FIH.EXE file. The Foreign Interface Harness dialog box appears. 2. Click OK. 3. Click Enable. 4. If a PIN has not been previously entered, click No. If a PIN was entered previously, click Yes. If clicking No, type and confirm the PIN, and then click OK. If clicking Yes, type the PIN and click OK. 58 Chapter 2 Installation ENWW