Kyocera TASKalfa 4500i Kyocera Command Center RX User Guide Rev-1.2 - Page 30

Settings Pages 6-8 USB Keyboard Type This tells the system the type of the keyboard being connected to the USB port. In order for the keyboard to properly operate, specify the correct type. Basic > Security > Device Security > General This page allows you to restrict access from the operation panel or USB host device. In addition, an explanation about each security setting is displayed. Lock Operation Panel Restricts access from the operation panel. With some models, this setting is irrelevant if the user has logged in as the Administrator. When it is set to Lock (Block), use of the System menu on this machine, registration in and editing of the Address Book and Box, use of the Stop key, and cancellation of jobs are forbidden. When it is set to Partial Lock, use of the System menu on this machine and registration in and editing of the Address Book and Box are forbidden. When it is set to Unlock, use of all keys is permitted. Filtering/Firewall, SNMPv1/v2, SNMPv3, SSL, IPSec, IEEE802.1x An explanation about each security setting is displayed. When you click a link in the sentence, the appropriate tab of the Advanced page opens. Basic > Security > Device Security > Interface Block This page allows you to restrict access from each interface. Network, USB Device, USB Host, Parallel I/F, Optional I/F Specifies whether or not to restrict access from each of the interfaces above. Access from the interfaces that are set to Block is restricted. Access from the network interface cannot be restricted. Access can be restricted on a per-protocol basis. Refer to the next section. Basic > Security > Device Security > Network Security This allows you to enable communication with the printing system on a perprotocol basis. SNMP v3, NetWare, AppleTalk, NetBEUI, Raw, IPP, IPP over SSL, HTTP, HTTPS, FTP (Transmission), FTP (Reception), SMB, SNMP, SMTP, POP3, LPD, LDAP, WSD Scan, WSD Print, ThinPrint, Enhanced WSD, Enhanced WSD over SSL Specifies whether or not to restrict communication via each of the protocols on the left. The communication via the protocols that are set to Block is restricted. The settings made on this page affect the protocol settings on the Advanced page. Basic > Security > User Login When the authentication function is set on the Advanced > Management > Authentication page (Local Authentication, depending on model), you must register users and set access levels on this page. The available access levels are User and Administrator. One administrator account is registered by default. Local Authorization turns On or Off Job Authorization settings for a user listed on User List. Registered shows the number of the current users. By entering a user name in Search by Name, you can search for the user. User Guide