Kyocera TASKalfa 4500i Kyocera Command Center RX User Guide Rev-1.2 - Page 68

Settings Pages Set the number of job logs for sending, from 1 to 1500. Run once now You can test this by clicking the Send button to immediately send a report. Advanced > Security > Secure Protocols You can encrypt communication between a PC and this machine using SSL encryption. For the changes made in the following to take effect, restart the machine as described in Basic > Defaults > Reset on page 6-6. SSL Specifies whether or not to use the SSL protocol. Serverside Settings • Effective Encryption Selects the encryption algorithm(s) to be used from DES, 3DES, and AES. • HTTP Security Specifies the security level. • Secure Only (HTTPS) Encrypts all HTTP protocol communication. Access is possible only with a URL that begins with "https://." Access attempts using an ordinary http:// URL are automatically redirected to the URL where "http://" is replaced with "https://." • Not Secure (HTTPS & HTTP) Enables access for both encrypted and unencrypted HTTP protocol communication. Access is possible with https:// and http:// URLs. The former URL establishes encrypted communication and the latter establishes normal communication. IPP Security Specifies the security level. • Secure Only (IPPS) Encrypts all IPP protocol communications. • Not Secure (IPPS & IPP) Enables access for both encrypted and unencrypted IPP protocol communications. Clientside Settings • Effective Encryption Selects the encryption algorithm(s) to be used from DES, 3DES, and AES. • Certificate Verification When set On, verify the expiration of the server certificate at communication. If found expired, communication will fail. When set Off, the expiration will not be verified. Note: When the SSL is set to On and HTTP Security is set to Secure (HTTPS), the document boxes cannot be accessed by the TWAIN driver. 6-46 User Guide