Kyocera TASKalfa 500ci 250ci/300ci/400ci/500ci/552ci Operation Guide Rev-1 - Page 263

Default Setting (System Menu) 1 Press the System Menu key. 2 Press [Common Settings], [ ], [Next] of Function Defaults, [ ], and then [Change] of E-mail Subject/Body. 3 Press [Subject] to enter an E-mail subject not more than 60 characters. NOTE: Refer to the Character Entry Method on page Appendix-7 for details on entering characters. 4 Press [OK]. 5 Press [Body] to enter an E-mail Body not more than 500 characters. 6 Press [OK]. 7 Check that the entries are correct and press [OK]. Border Erase Default Set the default width to be erased as a border. The table below shows the measurement ranges that can be set. Input units Range Inch 0 to 2" (in 0.01" increments) Metric 0 mm to 50 mm (in 1 mm increments) 8 NOTE: Refer to page 4-16 and page 5-23 for Border Erase. Use the procedure below to set the default border erase width. 1 Press the System Menu key. 2 Press [Common Settings], [ ], [Next] of Function Defaults, [ ] and then [Change] of Border Erase Default. 3 Press [+] or [-] for the Border and Gutter width to erase. You can use the numeric keys to enter the number directly. 4 Press [OK]. Border Erase to Back Page Select the Border Erase Method for Back Page of a sheet. The table below shows the available settings. Item Same as Front Page Do Not Erase Description Border Erase performed in the same setting as the front page No Border Erase performed on the back page NOTE: Refer to page 4-16 and page 5-23 for Border Erase. Use the procedure below to specify the border erase setting for the back of the page. 8-21