Kyocera TASKalfa 500ci 250ci/300ci/400ci/500ci/552ci Operation Guide Rev-1 - Page 292

Default Setting (System Menu) 4 Find the location on each chart where 2 lines most closely match. If this is the 0 position, registration for that color is not required. For the illustration, B is the appropriate value. From charts V-1 to V-5, read only the values from V-3 (center). 5 Press [Next] of Registration (Details). 6 Press [Change] for the chart to be corrected. 7 Press [+] or [-] to enter the values read from the chart and press [OK]. Press [+] to increase the value from 0 to 9. To decrease, press [-]. By pressing [-], the value changes from 0 to alphabetic letters, going from A to I. To move in the reverse direction, press [+]. You cannot use the numeric keys to enter these values. 8 Repeat steps 6 and 7 to enter the registration values for each chart. 9 Press [Execute] after all values have been entered. Color registration begins. 10 Press [OK] after color registration is complete. Color Calibration Cycle After Auto Clear has been activated, or during printing or while processing Color Registration, Performing Color Calibration... Remaining: 50 seconds may be displayed. While this message is displayed, the machine makes adjustments to maintain image quality. Wait until the message disappears. Set the color calibration cycle here. The setting items are as follows. Item Auto Short Standard Long Description Automatically sets the cycle for color calibration. Sets a short color calibration cycle and increases the number of times performed, with priority to image quality. Sets a standard color calibration cycle, compromising between image quality and downtime for processing. Sets a long color calibration cycle and decreases the number of times performed, to ensure minimal downtime. 8-50