Kyocera TASKalfa 500ci 250ci/300ci/400ci/500ci/552ci Operation Guide Rev-1 - Page 88
Collate/Offset Copying, Start, Without Document Finisher
View all Kyocera TASKalfa 500ci manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Basic Operation Ready to copy. Duplex Place original. Original Zoom Paper : --: 100% : --- Preview 1-sided >>1-sided 1-sided >>2-sided 2-sided >>1-sided 2-sided >>2-sided Book >>1-sided Book >>2-sided Status Add Shortcut Original Binding Left/Right Binding Top Cancel Copies Top Edge Top Original Orientation OK 10/10/2008 10:10 6 If you choose [2-sided>>1-sided], [2-sided>>2-sided], [Book>>1-sided] or [Book>>2-sided], select the binding edge of the originals of Original. 7 Press [Original Orientation] to select orientation of the originals, either [Top Edge Top] or [Top Edge Left]. Then press [OK]. 8 Press [OK]. 9 Press the Start key. Once an original placed on the platen is scanned, replace it with the next one. Then, press the Start key. After scanning all originals, press [Finish Scan] to start copying. Collate/Offset Copying The machine can collate and offset at the same time as it copies. You can use the Collate/Offset copy function for tasks such as those shown below. Collate 3 2 1 3 2 1 3 2 1 3 2 1 Scan multiple originals and deliver complete sets of copies as required according to page number. Original Copy Offset Without Document Finisher 3 2 1 3 2 1 3 2 1 3 2 1 Original Copy (each set) If the optional document finisher is not installed, when you use offsetting, printed copies are produced after rotating each set (or page) by 90º. NOTE: You need to load the same sized paper with different orientation in the paper source other than the selected paper source. The paper sizes supported in Offset are A4, B5, Letter and 16K. 3-14