LG PQCPA11A0E Owner's Manual - Page 45
Setting the netmask address
View all LG PQCPA11A0E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
2. Installing ACP Setting the netmask address After setting the gateway address, the netmask address should be set. Set the netmask address as follows: 1. Press the 'MENU/SELECT' button of the ACP and then press Left/Right ( , ) button to display the following Netmask setup screen. Press the 'MENU/SELECT' button again. The screen to enter the netmask address is displayed. MENU/ SELECT 2. Use Up/Down/Left/Right ( Click MENU /SELECT button [MENU] Set Netmask [Set Netmask] 192.168.000.000 ) button to enter the desired net mask address. MENU/ SELECT [Set Netmask] 255.255.255.000 Example to set Netmask address 3. After entering the netmask address, press the 'MENU/SELECT' button to set the entered netmask address. But, there is no 'MENU/SELECT' button pressed for a specific period (about 5 seconds), it returns to the initial screen with the entered netmask address not applied to the system, and the existing set netmask address is used. MENU/ SELECT ACP SW ver. 2.77.2 Installation/Owner's Manual 2-31