Lexmark T642 Service Manual - Page 112
Service checks, 5-Bin mailbox service check - review
UPC - 734646722001
View all Lexmark T642 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
4061-xx0 Service checks Anytime the system board is replaced, the Configuration ID must be reset in NVRAM. Go to "Configuration ID" on page 3-21. Review the following information before performing any service checks. • Paper feed problems (especially paper jams): Go to "Display Log" on page 3-23 and check the printer event log for indications of repetitive entries that help to isolate a problem to a particular area of the printer or option. • Paper feed problems with error message: Use the "Sub error codes for 9xx and 2xx error codes" on page 2-8 to help diagnose the problem. • Print quality problems: Go to "Print quality pages (Prt Quality Pgs)" on page 3-6 and print a test page to help diagnose problems before changing any settings or working on the printer. • Use the resident diagnostics test provided to help isolate a problem before taking the machine apart or removing any options. 5-Bin mailbox service check Service tip: The majority of the mechanical components can be observed during operation by removing the left and right side covers. Make sure the option(s) are correctly installed and the machine is configured correctly before attempting to service the unit. Problems with excessive static electricity buildup FRU 1 Front cover assembly Action Check the front cover assembly to make sure the ESD brush ground lead is firmly attached to the 5-Bin mailbox frame. Also check to make sure the ESD brush is not loose or damaged. The printer does not recognize one or more output options as installed Service tip: If more than a single output option is installed, check each one to see if the printer recognizes any single option as being installed. If the printer recognizes any of the output options then the base printer autoconnect system is operating correctly and the problem is in the unrecognized option. Continue with this service check or go to the service check for the failing output option. FRU 1 5-Bin mailbox option 2 Mechanical linkage assembly Action Check the autoconnects, cables, and connectors of the option for any signs of loose or damaged parts. Remove the left and right side covers and check the two autoconnects for damage, especially the connector pins. Remove the output option and check the voltages on the standard output bin autoconnect located on the top left rear of the printer. Go to "Autoconnect" on page 5-6. If the voltages are correct, reinstall the output option noting the position of the toroid on the autoconnect cable of the lower autoconnect. Check the voltages on each of the autoconnects. If the toroid was moved, make sure to move it back to its original position on the cable. If the voltages are correct, replace the control board. If the voltages are incorrect, replace the failing autoconnect assembly. 2-72 Service Manual