Lexmark T642 Service Manual - Page 97

4061-xx0 User attendance messages-paper jams and paper handling errors (2xx.xx) Error code Sub codes Description Possible causes 202 .20 Paper jam around fuser exit or redrive area. Fuser page count between 200,000 and 299,999. Paper may be jammed in fuser exit or redrive area. 202 .21 Page did not cleanly exit fuser or redrive area. Fuser page count between 200,000 and 299,999. Page may be jammed in fuser exit or redrive area. Action • Make sure the redrive door is complete closed. • Check the fuser for any signs of wear or contamination. If any are found, replace the fuser assembly. See "Fuser assembly removal" on page 4-26. • Turn media over to reduce +W curl. • Check upper redrive diverter and diverter spring for any signs of damage, a loose spring, or binding parts. Repair the redrive as necessary. • Check any installed output options(s) that may be installed for correct installation and alignment. • The fuser exit sensor may not be functioning properly. Go to "Fuser exit sensor service check" on page 2-92. • Make sure the redrive door is complete closed. • Check the fuser for any signs of wear or contamination. If any are found, replace the fuser assembly. See "Fuser assembly removal" on page 4-26. • Turn media over to reduce +W curl. • Check upper redrive diverter and diverter spring for any signs of damage, a loose spring, or binding parts. Repair the redrive as necessary. • Check any installed output options(s) that may be installed for correct installation and alignment. • The fuser exit sensor may not be functioning properly. Go to "Fuser exit sensor service check" on page 2-92. Diagnostic information 2-57